Tek-Air has provided laboratory airflow control systems since our incorporation in 1983. The experience gained through the completion of hundreds of installations, for a wide variety of customers, is reflected in our design philosophy. Our design for each project is intended to embody the following key elements of this philosophy.
Be it airflow, space pressure, or face velocity; if a parameter is important enough to be controlled, it should be measured directly. Most competitors of fume hood controls measure sash open area only and then position a calibrated mechanical volume regulator (springs, bearings, and levers) to achieve volumetric flow control.
Tek-Air has designed fume hood controls for many specialized Hood applications using three different methods of control.
> Control based on the Velocity Measurement of the air drawn from the room through the open sash over our velocity sensor. Virtually any occurrence which affects the face velocity is detected by the sensor, even those which are caused by improper use of the hood. This measured face velocity is used as the parameter for the controller to change the flow in the duct to maintain face velocity set point.
> Control based on Sash Position with Flow Measurement is an enhanced version of what our competitors provide using the sash position to determine the volume set point for the hood. Tek-Airtakes accuracy and safety a step further by providing flow measurement in the fume hood duct where the volume set point is used as an input to the controller which is monitoring and controlling the duct air flow.
> Control based on Constant Volume or Two Position Control where a constant face velocity at the sash is not as critical as the two other methods. Even though this is simpler to accomplish with less hardware, Tek-Air still measures and controls the duct air flow, and provides face velocity monitors to alarm individuals when the hood is outside of acceptable limits.
 |
The VT-2000 Airflow Measurement Probe consists of multi-sensor probes available as insertion probes or in pre-assembled airflow stations. Individual sensors provide frequency pulse outputs which are directly proportional and linear to airflow velocity.
|
 |
The VT-5000 Airflow Measurement Probe consists of multi-sensor probes inserted in the ductwork where airflow is to be measured and transmitted. Individual sensors on the probes provide pulse frequency electronic output signals which are directly proportional and linear to the airflow velocity. These signals are totalized in the companion transmitter and converted to an industry standard, 4-20mA output. (1-5 VDC or 2-10 VDC are also selectable by jumper).
|
 |
The VT-7000 Airflow Measuring Device consists of multi-sensor probes mounted on a bar and installed in the inlet of large fan inlets. Individual sensors on the probe provide frequency pulse type electronic output signals which are directly proportional and linear to airflow velocity. These signals are totalized in the companion transmitter and converted to an industry standard, 4-20mA output. (1-5 VDC or 2-10 VDC are also selectable by jumper.)
|
 |
The VT-8000 Airflow Measuring Device consists of multiple sensors which are mounted on the fan to provide frequency pulse type electronic output signals which are directly proportional and linear to airflow velocity. These signals are totalized in the companion transmitter and converted to an industry standard, 4-20mA output. (1-5 VDC or 2-10 VDC are also selectable by jumper.)
|
Hello, my name is Jack Sparrow. I'm a 50 year old self-employed Pirate from the Caribbean.