AW-Lake HUB-40 Flow Sensor

AW-Lake HUB-40 Flow Sensor it is Ideal for any industry or flow measurement application where an non-hazardous sensor is required, such as in hydraulic systems.

AW-Lake HUB-40 Flow Sensor

AW-Lake HUB-40 Flow Sensor Features:

• Square wave output signal has a duty cycle of approximately 50%.
• For use with most meter sizes of the following AW-Lake flow meters:

• JVM-xxx gear meters
• JVS-xxx gear meters
• JVHS-xxx gear meters
• ZHM-xxx gear meters
• HPM-xxx turbine meters
• HM-xxx turbine meters
• TRG-xxx turbine meters
• SRZ-xxx gear meters

Flow Sensor HUB-40 Series:

• Supply Voltage: 10-24 VDC
  
• Supply Current: 8 mA @ 12 VDC, 12 mA @ VDC
  
• Sensor/Monitor Frequency Output: Flow Dependent, 0.5 Hz minimum
  
• Output Ampliture: VHIGH = VSUPPLY - 0.7 Volts, VLOW = 0 Volts
  
• Duty Signal: 50% ± 15%
  
• Temperature Ratings: -20 to 85°C (-4 to 140°F)

Advantages:

• Up and Running in Minutes: Easy thread-in installation. A quick setup procedure allows you to have the sensor working with just a few simple installation steps.
• Flexible Mounting: Because of the integral swivel union, the HUB-40 unit can be rotated 360° for easy wiring. Options available to fit any AW Gear Meter or Turbine Meter.
• Weather-Proof Enclosure Optional NEMA 4X enclosure provides environmental protection from moisture and debris.
• Built-In Protection: The signal outputs are protected by a self-resetting fuse with a 50 mA nominal trip point.

AW-Lake HUB-40 Flow Sensor Specification:

• Supply Voltage: 10-24 VDC
• Supply Current:
  • 8 mA @ 12 VDC
  • 12 mA @ 24 VDC
• Sensor/Monitor Frequency Output: Flow dependent, 0.5 Hz minimum
  • Output Amplitude
  • VHIGH = VSUPPLY – 0.7 Volts
  • VLOW = 0 Volts
• Duty Signal: 50% ± 15%
• Connection Available
  • 3 pin connector
  • Flying leads
  • Junction bix with terminal block
  • JST Connector
• Temperature Ratings: -20 to 85°C (-4 to 140°F)

Download Data Sheet: Flow Sensor HUB-40 Series

Reference: aw-lake.com